TSC SP-TC200-0018 Top Inner Cover Replacement

Overview

The SP-TC200-0018 is a factory-new top inner cover, finished in blue, sold as an individually bagged replacement part. It addresses one specific failure mode: a cracked, discolored, or mechanically damaged top inner cover on a TSC TC200 label printer. Rather than sidelining a printer or replacing the whole unit over a broken cover, swap this single component and get the printer back in service. It's the right pick for maintenance stock in any facility running TC200 units on a print-and-apply or desktop labeling line.

Compatibility

This cover is built specifically for the TSC TC200 desktop printer. Confirm your printer's model plate reads TC200 before ordering — printer top covers are model-specific in fit and mounting points, and a cover built for a different chassis will not seat correctly even within the same brand's lineup.

Installation Notes

No tools or specs beyond standard TSC service procedures are documented for this part; treat it as a direct drop-in replacement for the OEM cover on a TC200. The printer itself supports USB 2.0 and serial interfaces with TSPL-EZ firmware — relevant context if you're servicing the unit while it's opened up, though the cover itself carries no electronics or wiring.

What's in the Box

• 1x TSC SP-TC200-0018 top inner cover (blue)

Packaged individually per bag, which matters for parts-room organization — no bulk unpacking or sorting required when pulling stock for a single repair.