TSC SP-COM-3001 UK Power Cord
The SP-COM-3001 is a genuine spare-part power cord fitted with a UK (BS 1363) plug, built for TSC thermal and label printers deployed in UK and Ireland facilities. If a printer shipped with the wrong regional cord, or a cord in an existing deployment has failed, SP-COM-3001 is the direct replacement rather than a generic third-party substitute.
Compatibility
This is a UK-market power cord from the TSC Power Supplies and Cords family, intended for TSC printer units that accept a standard IEC C13/C14-style mains connection at the printer end and require a BS 1363 three-pin plug at the wall end for UK electrical standards. Confirm your specific TSC printer model uses a standard IEC inlet before ordering, since cord connector types vary across TSC's printer lineup.
Installation Notes
No tools required — this is a direct plug-in replacement between the wall outlet and the printer's power inlet. Keep the cord routed clear of print mechanisms and paper paths during rack or desktop installs, and verify the printer's rated input voltage matches UK mains (230V) before energizing.
Weight is listed at 1.0 lb, consistent with a standard-length mains cord rather than a bulk or extended-run cable. The SP-COM-3001 carries a 2-year warranty, which covers the cord itself against manufacturing defects — a reasonable baseline for a low-cost spare part that typically only needs replacing after physical damage. Because it is a factory-new TSC part number rather than a generic aftermarket cord, it matches the original connector geometry and gauge for TSC's printer chassis, avoiding the loose-fit or strain-relief issues sometimes seen with third-party cords. For sites standardizing spares across a fleet of TSC printers, stocking region-specific cords like this one alongside the printers themselves in your label printer inventory avoids downtime waiting on a replacement. If you're planning a multi-site rollout, a power and connectivity planning guide can help you standardize cord and outlet types per region before deployment.
