TSC CUT-TH220-0001 Cutter Module
The CUT-TH220-0001 is a factory-new cutter module built specifically for TSC's TH220 and DH220 thermal transfer printers. It converts a standard label printer into an automatic cutting station, slicing labels or tags free at a defined point in the print job instead of leaving them on a continuous liner for manual tear-off. That matters on any line where an operator or downstream process needs a single, cleanly separated label ready to apply immediately — shipping stations, work-order tagging, and retail price-labeling runs where hand-tearing every label slows the line.
Compatibility
This module is built for the TSC TH220 and DH220 print engines only — it is not a universal cutter and should not be paired outside that model pair. Confirm your printer's exact model designation before ordering, since TSC's desktop and industrial lines use similarly-numbered but mechanically different chassis. For deployments running other TSC print engines, check the TSC catalog for the correct cutter or peeler accessory matched to that specific model.
Installation Notes
As a module-level accessory, this cutter mounts into the TH220/DH220 print mechanism rather than bolting onto the housing exterior — plan for brief printer downtime during install and keep the printer's own setup documentation on hand for cover removal and module seating steps. If you're speccing a new label station rather than retrofitting one, pair the printer and cutter as a single order to avoid a mismatch on receiving.
Pairing a CUT-TH220-0001 module with an active TH220 or DH220 deployment is the direct path to unattended label separation on a thermal transfer line — but confirm your firmware and driver settings support auto-cut mode before go-live, since cut-mode behavior is configured in the printer driver, not on the module itself. For broader planning on integrating label printers into a warehouse or POS network, see this guide to label printer selection. If your run also needs peel-and-present instead of full cut, look at TSC's peeler module for the same TH220/DH220 chassis rather than this part. Round out the station with compatible ribbon and label media sized to your print width, and if the printer sits on a shared network segment, route it through a managed PoE switch for consistent uptime monitoring alongside other line devices.
