STI KIT-71101A-G Stopper Station Back Box & Spacer Kit
Overview
The KIT-71101A-G is a mounting hardware kit that provides the back box and spacer components needed to install STI Stopper Station emergency communication devices in both surface and recessed wall configurations. This accessory handles the mechanical alignment and cable entry management required when integrating Stopper Station units into access control and emergency notification systems. The kit operates at 9VDC and includes frame, gasket, and cable entry spacer components.
Compatibility
This kit is designed for STI Stopper Station platforms. It supports surface-mounted and recessed installations where proper cable entry management and weatherproofing are required. The 9VDC operating voltage aligns with standard Stopper Station emergency communication devices. Verify the specific Stopper Station model you are installing before ordering — this kit provides the structural mounting interface, not the communication module itself.
Installation Notes
Installation requires a 7mm masonry drill bit for fixing holes. The kit includes a weather gasket for environmental protection and cable entry inserts to blank off unused connection points. Position the frame centrally over the device, mark the four fixing holes, drill through masonry, and secure with the wall fixings provided. For surface installations, use the spacer inserts to manage cable routing and seal unused entries. No special tools or torque specifications are documented beyond standard drill and screw fastening.
What's in the Box
- Stopper Station back box frame
- Weather gasket for environmental sealing
- Spacer kit with cable entry inserts
- Wall fixing screws (4x per standard installation)
- Cable gasket for wiring system integration
