STI BPA1008 EnviroArmour Aluminum Back Panel
Overview
The BPA1008 is a 10-inch by 8-inch aluminum back panel engineered for outdoor and environmentally demanding access control deployments. It provides a rigid, corrosion-resistant mounting substrate for credential readers, keypads, and biometric sensors where weather exposure and structural integrity matter. Install this where you need to extend the lifespan of reader hardware against salt air, temperature swing, UV exposure, and physical stress — aluminum construction handles these demands better than standard plastic mounting plates.
Compatibility
The BPA1008 integrates with STI access control reader systems and similar credential devices rated for 9VDC operation. It is designed as part of the EnviroArmour environmental protection family, supporting standard reader mounting architectures in parking garages, loading docks, exterior walls, and other exposed-environment installations. Verify your specific reader footprint and electrical requirements against STI documentation before ordering — the panel itself is a passive substrate and does not contain powered components.
Installation Notes
The aluminum panel requires four mounting holes (7mm diameter based on STI installation standards for similar weather-rated enclosures). Secure to masonry, metal studs, or composite surfaces using appropriate anchors for your substrate — do not rely on adhesive alone in high-vibration or wind-exposed locations. The 9VDC electrical environment specified indicates the panel will support standard low-voltage reader wiring; ensure all cable entries use appropriate gaskets or strain relief to prevent water ingress at penetration points. If the installation will see salt spray or corrosive industrial vapor, confirm the aluminum grade and anodizing thickness with STI — standard anodize provides moderate protection but may require periodic inspection in aggressive coastal environments.
