SDC/Security Door Controls CC3-5-7652 Cable 5ft Socket

SDC CC3-5-7652 5ft Input Power Socket Cable

Overview

The CC3-5-7652 is a 5-foot cable assembly with socket connector designed to extend power and monitoring connections between HID readers and SDC access control systems. This cable bridges controller-to-reader distance without signal degradation, solving the common install constraint where door frames or mounting geometry require separation beyond a reader's hardwired pigtail. Use this when you need clean signal path over standard run distances in commercial access control deployments.

Compatibility

Designed for SDC Security Door Controls systems supporting HID credential readers. The socket connector integrates with SDC controller infrastructure in multi-door access control environments. Confirm connector pinout with your specific SDC controller module before ordering — socket orientation and pin assignment must match.

Installation Notes

The 5-foot length accommodates typical door frame and controller mounting distances in commercial and institutional installations. Route cable through conduit where it crosses open walls or heavy-traffic areas to prevent damage. Socket connector must seat fully with no cross-pin installation — misalignment will cause intermittent credential read failures. Verify power supply capacity at the controller before extending multiple readers; each HID reader draw contributes to total load. No special tools required for socket connection, but ensure the mating connector on your reader or controller is clean and undamaged before engaging.