i-PRO PID9 Recessed Ceiling Mount Housing for WV-CS Series
The PID9 is a recessed ceiling mount housing for the i-PRO / Panasonic WV-CS camera series. Recessed housings install above the ceiling line so the camera sits flush with or below the ceiling tile, providing a clean architectural look in lobbies, executive areas, and high-finish retail spaces where pendant or surface-mount cameras would be visually disruptive.
Key Features
- Recessed ceiling housing for the WV-CS camera series
- Designed for above-ceiling installation in suspended or hard ceilings
- Architectural flush-mount aesthetic for high-finish spaces
- Maintains the camera's published image quality and ratings
- Pre-fitted trim ring for clean ceiling finish
- Standard ceiling tile cut-out dimensions for predictable install
- Compatible with the WV-CS series accessory ecosystem
Recessed ceiling housings serve a specific market: spaces where the camera must be present but visually inconspicuous. Hotel lobbies, executive office suites, high-end retail, and corporate boardrooms all want the surveillance footprint but reject the visible presence of a pendant or surface-mount dome. The recessed housing tucks the camera above the ceiling line with only the dome bubble flush at the ceiling surface, preserving the architectural design intent.
Plan the install around the actual ceiling structure. Suspended ceilings need above-tile support that does not depend on the tile alone; hard ceilings require an opening sized to the housing. Verify the camera's IR LEDs do not bounce off the ceiling structure and cause image artifacts. After install, run the camera through its full operating range and confirm image quality is at published spec — recessed installs are harder to service if image issues appear later.
