QNAP RAM-1GDR3L-SO-1600 1GB DDR3L SO-DIMM Memory Module
Overview
The RAM-1GDR3L-SO-1600 is a 1GB DDR3L SO-DIMM memory module running at 1600 MHz, sourced directly for use in compatible QNAP NAS systems. DDR3L's lower operating voltage compared to standard DDR3 reduces heat output inside the NAS enclosure — relevant in always-on, multi-drive deployments where thermal management directly affects drive and component longevity. This is an entry-level capacity module suited for light NAS workloads: basic file sharing, backup targets, and single-user SMB environments where the factory-installed RAM is the limiting factor. If you're running concurrent virtual machines, heavy surveillance recording streams, or multi-user iSCSI workloads, this module alone won't move the needle — look at higher-capacity options in the NAS storage accessories lineup instead.
Compatibility
This module is validated for compatible QNAP NAS units that accept SO-DIMM DDR3L at 1600 MHz. QNAP certifies specific RAM configurations per enclosure model — verify your NAS model's maximum supported RAM and slot configuration in QNAP's official compatibility list before ordering. Not all QNAP enclosures support user-upgradeable RAM; entry-level diskless models with soldered memory are not compatible. ADATA (ADDS1600X1G11-BSS) and Samsung modules are cited as validated components in this configuration.
Installation Notes
Installation requires partial disassembly of the NAS enclosure: loosen the three rear panel screws, remove the case cover, then locate the SO-DIMM slot on the board. The module seats at an angle and locks flat — standard SO-DIMM installation. Power down and unplug the unit fully before handling any internal components. No additional tools beyond a small Phillips screwdriver are required. Consult your specific NAS model's hardware guide to confirm slot location and any torque or ESD precautions relevant to that chassis.
