i-PRO AGC20020GM 20M Camera Head Cable
Overview
The AGC20020GM is a 20-meter camera head cable purpose-built for the i-PRO AG-MDC10G multiview decoder. It carries signal from remote camera heads to the central decoder in multi-camera surveillance installations where standard patch cables cannot span the distance reliably. A single 20-meter run (approximately 65 feet) eliminates the need for signal amplification or intermediate distribution equipment — meaningful when your decoder sits in a central rack and camera heads are mounted on distant walls or ceilings. This cable is the right fit for installations where extended cable runs would otherwise force you to add active repeaters or redesign your topology.
Compatibility
The AGC20020GM interfaces exclusively with the i-PRO AG-MDC10G multiview decoder system. It connects the decoder's camera head ports to remote surveillance camera heads within that ecosystem. Before ordering, verify your AG-MDC10G installation and firmware version match the cable specifications — incompatible decoder versions may introduce impedance mismatch or signal integrity issues over the 20-meter span, resulting in visible artifacts or intermittent connection loss.
Installation Notes
Observe minimum bend radius during routing to avoid impedance discontinuities that degrade signal quality — this is critical over 20-meter distances where reflections compound and cascade through the entire run. Route cable away from high-voltage AC lines and RF sources to prevent coupling noise that degrades signal-to-noise ratio. Test signal integrity at installation before committing the run to conduit or permanent mounting — catching issues before the cable is buried saves costly rework. Hand-guide the cable through tight spaces rather than forcing it; excessive strain on connectors during the pull can damage internal contacts and cause intermittent failures after deployment.
What's in the Box
- 1x 20-meter camera head cable (AGC20020GM)
