Paige Electric 7106A06WH Cat 6A White 6-Inch Patch Cord

Overview

The 7106A06WH is a 6-inch Cat 6A patch cord from Paige Electric, built for the short jumps between patch panels and switches where a full-length cable creates unnecessary slack and cable-management headaches. Cat 6A construction supports Gigabit and Multi-Gigabit speeds, so this cord holds up whether the switch port is running standard Gigabit today or gets bumped to 2.5/5/10GbE later without a cabling change. At 0.04 lb, it adds negligible weight and bulk in a fully loaded rack, which matters when you're running dozens of jumpers across a patch field and airflow or door clearance is already tight.

Compatibility

As a standard RJ-45 Cat 6A cord, the 7106A06WH terminates into any Cat 6A or backward-compatible Cat 6/Cat 5e jack, patch panel port, or switch port — no vendor lock-in. It's the right length for rack-to-rack or panel-to-switch jumpers in structured cabling enclosures where the panel and switch sit within a few inches of each other, rather than for longer runs to wall plates or workstations.

Installation Notes

Rated as a power-limited circuit cable, so it's suited to standard low-voltage structured cabling pathways rather than power or high-voltage runs. Confirm the target port supports Cat 6A termination to get full Multi-Gigabit performance — plugging into older Cat 5e infrastructure will cap throughput to that segment's rating. Country of origin is China; the unit ships under a limited warranty.