Panduit FW2LU1U1ONM0.5 OM5 Fiber Cable - FW2RLU1U1ONM0.5

Panduit FW2RLU1U1ONM0.5 OM5 LC Duplex Fiber Patch Cable

Overview

The Panduit FW2RLU1U1ONM0.5 is a 2-fiber OM5 wideband multimode (50/125µm) LC duplex patch cable from the QuickNet™ pre-terminated fiber line. It is built for rapid deployment in data center, telecom room, and equipment distribution scenarios where field termination introduces risk and pre-terminated assemblies cut installation time. OM5 wideband multimode supports wavelength division multiplexing (WDM) techniques — specifically shortwave WDM (SWDM) — meaning this cable can carry multiple 25G or 100G lanes over a single fiber pair, extending useful distance beyond what standard OM3/OM4 can handle for emerging high-density switch fabrics. The LSZH jacket keeps halogen emission low in enclosed or plenum-adjacent spaces where smoke toxicity matters during an event. Standards compliance to TIA-568.3-D, ISO/IEC 11801, and ANSI/TIA-942-B means it integrates cleanly into audited fiber optic cabling infrastructure without triggering compliance exceptions on structured cabling documentation.

Compatibility

The LC duplex uniboot connector format fits any LC-equipped active equipment or patch panel port: top-of-rack switches with LC SFP+ or SFP28 transceivers, fiber patch panels with LC adapter plates, and pre-terminated trunk cassettes using LC duplex ports. OM5 is backward-compatible with OM3 and OM4 equipment — transceivers and switch ports that accept OM4 will accept this cable without penalty, though you will not gain WDM capability unless both ends support SWDM optics. The uniboot construction consolidates both fibers into a single slim jacket, which reduces pathway congestion in high-density cable management trays compared to standard duplex zip-cord assemblies. The 0.5m length targets within-rack or adjacent-rack interconnects; confirm actual port-to-port run before ordering longer assemblies.

Installation Notes

LSZH jacketing is required by code in many European and transit installations; verify local NEC or building code requirements before substituting a standard PVC-jacketed cable. The uniboot design maintains fiber polarity — confirm polarity scheme (A-to-A or A-to-B) matches your cassette or patch panel before mass deployment. Minimum bend radius for 2mm tight-buffered fiber applies; avoid sharp bends at patch panel entry points, particularly in high-density installations where cable weight can create sustained stress on the ferrule.