Middle Atlantic PN10F11FW 90-Degree Flat Elbow

Overview

The PN10F11FW is a 90-degree flat elbow designed for the Middle Atlantic PN10 series wire management system. It solves the practical routing problem of turning a cable run at a right angle within a flat plane — specifically for horizontal direction changes along walls, above suspended ceilings, or within equipment rooms where vertical transitions aren't needed. When a straight cable management raceway run must change direction without rising or dropping, this flat elbow keeps the conduit path clean and code-compliant without forcing a custom bend or a loose junction.

Compatibility

The PN10F11FW is purpose-built for the Middle Atlantic PN10 series raceway system. It mates directly with PN10 series straight sections, couplings, and other fittings in that family. If you are working with a different Middle Atlantic raceway series — such as the PN5, PN7, or PN15 — this elbow will not fit; series fittings are not interchangeable across raceway sizes. Verify your installed raceway series before ordering. For a full view of compatible fittings and straight sections, see the cable management accessories category.

Installation Notes

Install the PN10F11FW at any point in a PN10 run where a 90-degree horizontal direction change is required. The flat geometry keeps the elbow flush to the mounting surface, which matters in tight above-ceiling or wall-chase installations where a raised or offset fitting would conflict with adjacent structure. Ensure the adjoining PN10 straight sections are fully seated into the elbow before securing to avoid stress on the fitting joint. No special tools are required beyond standard raceway installation hardware used throughout the PN10 system.