Middle Atlantic NM 90 D. Flat Elbow NM200 - NM2011

Middle Atlantic NM2011 90-Degree Flat Elbow for NM200 Cable Manager

Overview

The Middle Atlantic NM2011 is a 90-degree flat elbow fitting designed for use with the NM200 series horizontal cable management system. It allows NM200 cable runs to make clean right-angle turns within a rack or pathway installation — solving the common problem of directing bundled cables around corners without kinking, overstressing, or leaving a gap in the managed pathway. If your cable route requires a horizontal direction change, the NM2011 provides the matching bend geometry to keep the managed channel continuous.

Compatibility

The NM2011 is designed for use with the Middle Atlantic NM200 series horizontal cable management system. It is specifically a flat elbow variant for in-plane 90-degree turns, and should be matched to the NM200 channel profile. Verify the NM200 channel orientation and mounting configuration at the turn point before ordering — flat elbows are intended for horizontal-plane direction changes, not vertical drops.

Installation Notes

Install the NM2011 at the point where the NM200 cable run changes direction by 90 degrees. Ensure the elbow is aligned flush with the adjoining NM200 channel sections to maintain consistent cable bend radius through the turn. No special tooling is specified for the fitting itself; follow standard rack cable management practices for securing cable bundles at the transition point to prevent cable pull-through.