Lifesafety Power FPO75/150-C8D8E4A Power Supply Enclosure
Overview
The Lifesafety Power FPO75/150-C8D8E4A is a 225W access control power supply purpose-built for multi-door installations requiring simultaneous 12V and 24V output rails. This is the platform to deploy when you need to power AMAG badge readers, mag locks, and relay-controlled door hardware in parallel without daisy-chaining separate supplies or burning circuit capacity. The model ships in a standard E4A steel enclosure (24H × 20W × 4.5D inches) sized for surface-mount or cabinet rack integration on a standard 19-inch wall.
Compatibility
Direct compatibility with AMAG access control systems and readers requiring dedicated 12V and 24V rails. The FPO75/150-C8D8E4A includes 8 relay outputs (8 DIN relay modules), enabling independent circuit control for up to 8 door strike/lock zones without external relay boards. This design eliminates the need for separate relay modules if your system uses standard 24V solenoid locks and AMAG badge readers operating at 12V. Verify your specific AMAG controller version in your system documentation before installation to confirm port compatibility.
Installation Notes
The dual-output design means strict load balancing is required during configuration — 225W total capacity is divided across 12V and 24V rails, so overloading one rail will trip the supply. Typical installation involves breaker-protected 120V AC line input wired to the internal transformer and capacitive discharge circuit. The 8 relay outputs are 24V logic control lines; size your door-strike wiring separately according to your strikes' amperage draw (typically 0.6–1.2A per strike). Mount in a climate-controlled electrical room or cabinet — the enclosure does not include environmental sealing for wet or outdoor mounting. Ensure adequate ventilation (minimum 3 inches clearance on all sides) to prevent thermal shutdown under sustained full-load draw.
