Lifesafety Power FPO150-B150M8NLCE2M1 150W Managed Power Supply

Overview

The FPO150-B150M8NLCE2M1 is a 150W regulated power supply with eight independently fused outputs, each rated at 3A maximum draw. Selectable at installation to deliver 12VDC or 24VDC—a constraint that matters: you must choose one voltage for the entire unit at commissioning; you cannot mix outputs. The 12A (12V) or 6A (24V) primary rating reflects the total source capacity; individual output fusing ensures downstream protection and partial-load survival if a single endpoint fails or draws excessive current. Deploy this where you need managed, protected power distribution to multiple IP cameras or networked access control readers across a warehouse, facility perimeter, or multi-zone indoor installation—situations where a single PSU failure should not take out an entire deployment.

Compatibility

Verify input specifications with your PoE switch or upstream power infrastructure before selection. The FPO150-B150M8NLCE2M1 accepts standard AC mains input and delivers either 12VDC or 24VDC output. Eight independent outputs suit deployments with 6–8 powered endpoints per supply unit. Confirm exact voltage requirement of downstream cameras, readers, or sensors before commissioning; voltage selection is not field-reversible without power-down and potential reconfiguration.

Installation Notes

Each of the eight outputs is individually fused at 3A maximum. This per-channel protection limits load per output to 36W (12V) or 72W (24V)—validate that your powered endpoint draws remain within this ceiling per channel. Budget installation time for voltage selection at setup and verification of each output load during commissioning. The unit requires standard AC mains inlet and controlled DC distribution wiring to downstream endpoints.