Lifesafety Power FPO150-B100C8PD8PE6M 150W Access Control Power Supply
Overview
The FPO150-B100C8PD8PE6M is a 150W power supply designed for distributed access control and door management installations. It delivers either 12A at 12VDC or 6A at 24VDC from a single input, with a secondary adjustable output (5–18V @ 4A max) for auxiliary powered endpoints. The unit fits the E6 enclosure form factor (30H × 23W × 6.5D inches) with a Mercury back plate, making it suitable for wall-mount or rack integration in security closets and equipment rooms.
Output and Relay Architecture
The unit provides 8 Class 2 power-limited relay lock control outputs, each rated 2.5A, with per-output selectability for failsafe, failsecure, or FAI (field-accessible inputs) logic. This granular control eliminates the need for external relays when managing multiple electronic locks or strike gates on independent failsafe/failsecure policies. An additional 8 DC auxiliary outputs (Class 2, 2.5A per channel) route to Bus1 or Bus2, allowing supervision of remote door sensors, request-to-exit buttons, or auxiliary 24VDC loads across dual buses.
Compatibility and Integration
This supply pairs with access control panels requiring standalone power distribution and relay supervision. The dual bus architecture supports distributed door control layouts where sensor and lock feedback must remain isolated by zone or access point. Verify input voltage availability (typically 16–28VAC or equivalent DC source) before ordering.
Installation Constraints
The E6 enclosure housing and Mercury back plate are fixed; internal relay/output wiring follows Class 2 power-limited standards and requires certified integrator configuration per NEC Article 725. Ensure adequate ventilation around the 30-inch height profile if mounted in confined spaces. All 16 outputs share the same chassis ground and require proper wire gauge and termination to handle 2.5A continuous per channel.
