Lifesafety Power FPO150-B100D8PM8NLCE4M1 150W Power Supply

Overview

The FPO150-B100D8PM8NLCE4M1 is a 150W regulated power supply designed for access control, alarm, and distributed surveillance installations where you need stable 12V or 24V feeding multiple low-current loads. It outputs 12A at 12V or 6A at 24V — enough to power a medium-scale door controller network, card readers, or auxiliary access equipment without dedicated per-device supplies. The real advantage: eight selectable DC auxiliary outputs, each fused at 3A and individually configurable for Bus1 or Bus2 operation, giving you granular control over which loads draw from which circuit leg. This matters on multi-zone systems where you need independent fault isolation.

Compatibility

This supply integrates into Lifesafety Power ecosystems and compatible third-party access control platforms using standard 12V/24V DC distribution architecture. It supports Bus1 and Bus2 configurations, allowing parallel operation or independent redundancy depending on your system topology. Verify compatibility with your access control panel, card reader module, or distributed node architecture before purchase — the eight managed outputs make this a backbone feeder for medium-scale deployments, not a single-device supply.

Installation Notes

Class 2 power-limited design means each output is current-limited at 2.5A per auxiliary port, with 3A fusing on the managed distribution module. Wire gauge and conduit sizing depend on your load current draw and run distance — typical 12V runs at 10A or higher warrant 10 AWG or larger to avoid voltage sag. The selectable Bus1/Bus2 outputs let you split loads across two independent supply legs for fault tolerance — configure according to your site's zone criticality and backup strategy.