Lifesafety Power FPO150-B100C82D8PE4M/T8-C Prewired Mercury 8DR Power Supply

Overview

The FPO150-B100C82D8PE4M/T8-C is a 150W prewired access control power supply engineered for small-to-medium commercial deployments requiring distributed 12V and 24V power to door locks and auxiliary circuits. This unit delivers 4A at 12V and 4A at 24V simultaneously, supporting up to 8 door locks with 16 additional auxiliary outputs. The Mercury series comes prewired with MR52 connectors and tie-wrap bundles, eliminating field termination time and reducing installation error. Use this when your access control cabinet or distributed node needs factory-verified wiring harnesses ready for immediate panel integration.

Compatibility

The FPO150-B100C82D8PE4M/T8-C is designed to integrate with access control systems requiring dual-voltage outputs: systems using standard 12VDC solenoid locks and 24VDC auxiliary devices (relay modules, LED indicators, request-to-exit buttons, door sensors). The prewired MR52 connectors are industry-standard termination points for most commercial access control panels and door control modules. Confirm voltage and connector compatibility with your specific access control system before deployment—this unit does not include analog/digital conversion and is intended as a power distribution source only, not a control interface.

Installation Notes

The prewired harness configuration arrives ready for panel mount or rack integration; no field termination required if using standard MR52 connectors on your control equipment. Verify adequate chassis ventilation—150W continuous output generates heat, especially under peak load (8 amps across both rails simultaneously). This supply is intended for indoor, temperature-controlled cabinet environments. Do not exceed the rated amperage on either rail; overload will trigger internal protection. The tie-wrap bundling allows for organized routing within standard 19-inch rack or wall-mount enclosures.