Lifesafety Power FPO150/250-B1002C8P2D8PE4M1 Mercury Unified Power Supply
Overview
The FPO150/250-B1002C8P2D8PE4M1 is a 400W Mercury Unified Power Supply designed to distribute and manage power across access control, security intercom, and surveillance system installations. Built for dual-voltage operation (120 VAC input), it provides 16 relay lock outputs and 16 auxiliary outputs — sufficient capacity to drive multiple door locks, entry readers, emergency panels, and ancillary security devices from a single hardwired power source. Deploy this where you need centralized backup power distribution without running separate power lines to each endpoint.
Compatibility
The FPO150/250-B1002C8P2D8PE4M1 integrates with Mercury Unified Power ecosystems and access control systems that accept 120 VAC input and support relay-controlled lock outputs and auxiliary signaling. Confirm your door lock, reader, intercom, or control panel voltage and relay signal requirements before installation — relay output capacity is limited to the per-channel ratings specified in the product documentation. For systems requiring 24 VDC or 12 VDC outputs, verify that this unit's auxiliary outputs are configured for your target voltage.
Installation Notes
Install in a dry, climate-controlled enclosure — do not expose to moisture, high humidity, or temperature extremes outside manufacturer specifications. Mount securely to prevent vibration during operation. Wiring must be performed by a qualified electrician: 120 VAC input should be hard-wired to a dedicated, properly-grounded circuit breaker. Each relay output drives individual door strike circuits; do not exceed the per-relay current rating. Auxiliary outputs deliver low-voltage signaling — keep high-current lock lines and low-voltage logic lines in separate conduit to prevent inductive interference. Test all 16 relay outputs and 16 auxiliary outputs before commissioning — verify no lock or device fails to operate under full load.
