Lifesafety Power FPO150/250-2C83D8PE8M2/T16-A 16-Output Power Supply/Charger
Overview
The FPO150/250-2C83D8PE8M2/T16-A is a 400W dual-voltage power supply designed to centralize power distribution across multi-camera and access control deployments. It provides 12A at 12VDC and 10A at 24VDC output—enough capacity to run a mixed fleet of IP cameras, card readers, locks, and auxiliary devices from a single cabinet-mounted unit. The 16 individual output channels allow granular supervision and circuit-level control, critical in warehouse automation and facility-wide security integrations where per-device fault detection and independent reset capability reduce troubleshooting time.
Compatibility
The FPO150/250-2C83D8PE8M2/T16-A is part of the Lifesafety Power commercial platform and integrates with 12VDC and 24VDC camera systems, access control panels, and auxiliary load networks. Verify voltage requirement (12V or 24V) of each connected device before assignment to output channels; mixed-voltage deployment requires careful load balancing across the dual-voltage bus. Compatible with standard 24-pin plug-in modules and Mercury prewired harness configurations.
Installation Notes
Mount in a climate-controlled equipment rack or wall-mounted enclosure to maintain thermal stability during sustained 400W output. Allow minimum 3 inches of ventilation clearance around the unit. Wire outputs using 16 AWG or heavier copper conductor rated for the assigned amperage per channel. Tie-wrap routing (included with prewired Mercury configuration) manages multiple outputs and reduces electromagnetic noise coupling to camera signal paths. Inspect each output fuse before live deployment; failure of a single 12A or 10A channel fuse does not affect remaining 15 output branches.
