Lifesafety Power FPO150/250-2C82D8E8S Dual-Output Power Supply Enclosure
Overview
The FPO150/250-2C82D8E8S is a 400W enclosed power supply designed for multi-camera surveillance deployments requiring simultaneous 12V and 24V rails. The dual-voltage architecture supports 16-channel configurations where mixed-voltage equipment (12V cameras, 24V alarm panels, 24V lens motors) must run from a single supply. The E8S enclosure measures 36H × 30W × 4.5D inches — a standard 19-inch rack-mount profile that fits cleanly into security equipment racks without requiring custom shelving or adapters.
Compatibility
This supply is designed for Lifesafety Power 16DR SWH Pro installations and compatible with surveillance systems using independent 12V and 24V power distribution. Confirm your control panel or hub explicitly supports this supply model before installation. The 400W capacity accommodates typical camera loads (6–14W per unit depending on sensor and IR power) across 16 channels plus accessory devices (door strikes, relays, auxiliary sensors). If your system requires dedicated secondary backup power (UPS failover), plan additional battery modules separately.
Installation Notes
Mount in a secure, climate-controlled enclosure or equipment rack. Input voltage is standard North American 120VAC; verify your site power before deployment. The dual outputs are internally isolated — each rail (12V and 24V) draws from a shared power budget, so combined load across both rails cannot exceed 400W. Use appropriately gauged wire (refer to your installer's manual for specific AWG requirements per voltage/current). Ensure all connections are strain-relieved and labeled to prevent cross-voltage wiring errors. Periodic load testing is recommended for installations running 24/7 recording or high-draw accessory loads.
