Lenovo 4XF7A97374 Thinksystem Toolless Slide Rail KIT V4 with 2U CMA - for LEN

Lenovo 4XF7A97374 Toolless Slide Rail Kit V4 with 2U CMA

Overview

The Lenovo 4XF7A97374 is a toolless slide rail kit (V4 generation) with an integrated 2U cable management arm (CMA) for rack-mounted ThinkSystem servers. At 10 lb, the assembly is built for full-depth enterprise racks where clean cable routing and single-technician serviceability matter — the toolless design means you can pull a server forward for maintenance without disconnecting cables or reaching for a screwdriver. The CMA keeps power, network, and management cabling organized and protected through repeated extension and retraction cycles, which matters in dense racks where cable stress is a routine failure point.

Compatibility

Designed for Lenovo ThinkSystem 2U server platforms. The V4 designation aligns this kit with the current-generation ThinkSystem V3 and V4 server chassis that use the updated rail interface — confirm your server's generation and chassis depth against Lenovo's rail compatibility matrix before ordering, as V1/V2/V3 rail kits use different attachment points and are not interchangeable with this assembly. Compatible racks must support standard EIA-310 19-inch rail spacing. Verify rack post type (square-hole, round-hole, or threaded) against Lenovo's supported rack list for this kit.

Installation Notes

Toolless installation requires no additional hardware for rail-to-rack attachment on compatible square- or round-hole racks; threaded-post racks may require separate cage nuts. The CMA attaches to the rear of the slide rails and to a fixed rear rack post — confirm you have a free rear-post attachment point before deployment. Route cables through the CMA prior to final server seating to avoid rework. Manufactured in Mexico (country of origin: MX).