Honeywell 205-189-001 Self-Strip Cable Termination Module

The 205-189-001 is a self-strip module for Honeywell scanning and mobility cable assemblies, built for wired connections where field techs need to terminate or re-terminate cable runs without a separate stripping tool. If you're maintaining a fleet of Honeywell scanning hardware and need a spare termination module on the shelf rather than downtime waiting on a full cable replacement, this is the part-level fix.

Compatibility

This module is built for the Honeywell scanning and mobility product line and is not a universal part — confirm your specific scanner or peripheral cable interface against Honeywell's own documentation before ordering, since self-strip modules are typically matched to a specific cable/connector generation within a product family. Pair it with Honeywell scanners already deployed in your environment rather than mixing across unrelated brands.

Installation Notes

As a self-strip design, the module terminates the cable conductor without requiring a separate manual wire-strip step, which cuts install time on bench repairs and field swaps alike. It's a wired-interface component, so plan for a hardwired run rather than a wireless workaround — factor this into cable routing if you're refreshing a checkout lane or a mobile computing cart. At 6.66 lb, it ships and stores as a compact bench part rather than a bulk item, so it's practical to keep a few on hand as spares for a mobile computing deployment.

Why Stock This

Cable failures are one of the most common reasons a handheld scanner or mobile computer goes down on the floor. Keeping a 205-189-001 in your spares bin means a bad termination doesn't turn into a multi-day RMA cycle. It's sourced as factory-new hardware, not a grey-market substitute, so it goes into service the same way the original part did. For broader planning around scanner uptime, see a barcode scanner selection guide before standardizing your spares strategy across sites.