Honeywell HA35CNM01 Corner Mount Bracket
The HA35CNM01 is a corner mount bracket built for Honeywell 35S series camera installs where a flat wall or ceiling surface isn't available. If you're placing a camera at a building corner to cover two approach angles from one position, this bracket lets you do that without a custom fabrication job. It's a wired mount — no battery or power electronics on board, just the physical interface between the camera housing and the corner surface.
Compatibility
The HA35CNM01 is built for the Honeywell 35S camera series. It pairs with the broader 35S accessory set, including the HA354SC01 sunshield, HA35CLM02 ceiling mount, and HA35JCBHDV junction box, so you can spec a corner installation and still add weather or wiring accessories from the same family. Confirm your specific 35S camera model accepts corner mounting before ordering — mount geometry is model-specific across camera families.
Installation Notes
This is a wired mount: plan cable routing through the corner mount body to the camera, rather than relying on a wireless or battery-powered link. Corner mounting works best where you need dual-angle coverage from a single fixed point (building corners, hallway junctions) instead of a flat wall or ceiling run. Because manufacturer documentation for this specific SKU is limited on torque and hardware specs, verify screw sizes and load rating against the 35S camera's own installation guide before finalizing a commercial deployment.
For projects that also need pole or ceiling coverage in the same building, the HA35CLM02 ceiling mount and HA60PMC4FO pole mount adapter cover those angles within the same accessory line — worth speccing together to standardize hardware across a site.
