Geovision GV-MOUNT300-81 Convex Corner Adapter

Overview

The GV-MOUNT300-81 is a convex corner adapter designed to position IP PTZ cameras at corner installations where standard wall or ceiling brackets create dead zones or poor sight lines. Corner mounting on building exteriors, warehouse perimeters, or interior corridor intersections is where this adapter earns its place — it allows the camera to angle outward from the corner rather than straight into the junction, eliminating the blind spot a typical bracket would create. The convex geometry matches Geovision PTZ mechanical interfaces, ensuring secure, repeatable positioning without requiring custom fabrication or reinforcement.

Compatibility

The GV-MOUNT300-81 integrates with Geovision IP PTZ camera systems. Confirm your specific camera model supports the standard Geovision PTZ mounting interface before ordering — the adapter is designed for the mechanical footprint of Geovision's PTZ product line and will not work with dome, bullet, or turret fixed cameras, nor with PTZ systems from other manufacturers. If you are unsure whether your camera is compatible, verify the camera's mounting specification against the GV-MOUNT300 installation guide.

Installation Notes

Corner mounting requires solid structural backing — verify wall or pole depth and material load rating before installation. The adapter's convex radius is engineered for standard 90-degree corners; non-standard angles or curved surfaces may not seat properly. Use the mounting template included with the installation guide to mark fastener locations. Ensure all mechanical fasteners are fully tightened to prevent drift under wind load or PTZ motor vibration. Outdoor installations should apply stainless-steel hardware to prevent corrosion at the adapter-to-camera interface.