ACTI Exterior Fixed - Acs-E1CB-Adu-Bosch-Pb-NDM7703AL-Hrn-Audio

ACTi ACS-E1CB-ADU-BOSCH-PB-NDM7703AL-HRN-AUDIO Exterior Fixed Accessory

Overview

The ACS-E1CB-ADU-BOSCH-PB-NDM7703AL-HRN-AUDIO is an exterior fixed mounting and integration assembly designed for ACTi surveillance cameras in outdoor deployments. This accessory handles the mechanical and electrical interface between your camera and a Bosch-series integration frame, designed to support fixed-angle installations on building facades, soffit lines, or overhead structures where pan-tilt is not required. The model number itself encodes the compatibility chain—verify your camera model against the full part number before ordering, as ACTi product codes embed specific sensor, lens, and integration variants.

Compatibility

This assembly is engineered for use with ACTi cameras paired with Bosch integration hardware (indicated by the "BOSCH-PB" designation in the part number). The NDM7703AL reference points to a specific Bosch interface standard. Before purchase, confirm your camera's exact model number matches the compatibility matrix for this accessory—ACTi exterior fixed assemblies are not interchangeable across different camera generations or integration partners. Contact your ACTi channel partner with your camera model and mounting environment (building material, angle, exposure) to verify fit and electrical compatibility.

Installation Notes

Outdoor installation requires weatherproof sealing of all cable entry points and junction boxes. Use stainless steel or corrosion-resistant hardware—standard steel fasteners will degrade in most climates within 12–18 months. Ensure adequate strain relief on network and power cables to prevent water ingress at terminations. Verify that the mounting surface can support the combined weight of the camera, housing, and bracket under wind load (specific torque and load specs should be confirmed with ACTi technical documentation for your assembly variant). Test all electrical connections before final closure—water trapped in live connectors creates shock and short-circuit hazards.