ELO Touch E214282 USB to USB-C/DC-IN Power Cable

Overview

The ELO Touch E214282 is a 3-meter power cable designed to connect USB power sources to devices with USB-C or 2.1mm DC-IN connectors. This length eliminates the need for daisy-chained adapters or extension cords in fixed installations where the power source and target device are separated by typical wall-run or conduit distances. The cable carries both power and signal over USB, reducing clutter and installation complexity in point-of-sale, kiosk, and display mounting scenarios.

Compatibility

The E214282 terminates in USB-C and 2.1mm DC-IN connectors on one end, making it compatible with ELO Touch displays, payment terminals, and industrial tablets that specify USB power input or 2.1mm barrel connectors. Verify your device's charging port against the connector type before purchasing — mismatched connector geometry will not fit. The USB source end accepts standard USB Type-A or Type-C power supplies rated 5V or higher (confirm your PSU voltage to avoid device damage).

Installation Notes

Route the cable through conduit or cable trays to avoid trip hazards and physical damage in high-traffic areas. Keep the cable away from sharp edges and pinch points during wall mounting. The 3-meter length accommodates most under-counter or wall-mounted installations; do not extend with unpowered USB extension cords — use a powered hub or additional supply if longer runs are needed. Store excess coil loosely to prevent conductor strain at connector stress points.