ELO Touch E951381 USB Type-A to Type-C Cable

Overview

The ELO Touch E951381 is an 18-meter USB Type-A to Type-C cable designed to extend connectivity between ELO Touch devices and USB-C-equipped peripherals or host systems. At 18M (approximately 59 feet), this cable bridges the gap between control units and remote sensors, displays, or powered devices without requiring additional hubs or adapters. Use this where a single run from your control point to a distant ELO Touch endpoint avoids intermediate junction boxes and simplifies wiring.

Compatibility

The E951381 connects any ELO Touch device with a USB Type-A port to equipment featuring a USB Type-C connector. Verify your specific ELO Touch model supports USB Type-C input before ordering — not all ELO Touch devices use Type-C connectors. The cable is passive (no active electronics), so it will work with any standard-compliant USB Type-C endpoint. Confirm your host device supports the data protocol (USB 2.0, USB 3.x, or power delivery) your application requires.

Installation Notes

At 18 meters, cable runs should avoid sharp bends and high-stress flexing at connector ends — coil excess cable loosely to prevent stress on the Type-A and Type-C connectors. Route the cable away from high-current power lines and RF sources if data integrity is critical. If the cable must pass through conduit or cable trays, ensure the duct diameter allows the connectors to pass without forcing. Test connectivity before final installation to confirm the full length does not degrade signal for your specific data rate or power delivery requirement.