Middle Atlantic DGT Plate W/ Extron AAP O - DGT-AAP

Middle Atlantic DGT-AAP Plate with Extron AAP Opening

Overview

The DGT-AAP is a blank faceplate for Middle Atlantic DGT series rack and credenza furniture that incorporates a pre-cut Extron AAP (Architectural Adapter Plate) opening. It solves a common AV integration problem: you need to route signal connections through a finished furniture panel without cutting a custom hole on-site. Drop an Extron AAP module — HDMI, VGA, USB, or any AAP-format insert — directly into the DGT-AAP plate for a factory-finished appearance inside a rack or millwork enclosure. This is the correct part when your AV or security equipment rack uses DGT furniture and you are already standardized on Extron AAP-format connectors for signal management at the furniture face.

Compatibility

Designed for the Middle Atlantic DGT series furniture line — including DGT credenzas, DGT rack enclosures, and DGT AV furniture panels that accept accessory plates in the standard DGT faceplate format. The AAP opening accepts standard Extron AAP (Architectural Adapter Plate) inserts, which are available in a wide range of connector types across the AV furniture accessories category. If your installation uses a different Middle Atlantic furniture series (such as the BGR, PAN, or C2 lines) or a different AAP-format standard (Lutron, AMX, or Crestron snap-in), this plate is not the correct fit — verify the DGT panel slot dimensions before ordering. For builds that require rack panel management without a signal opening, Middle Atlantic offers standard DGT blank plates in the same family.

Installation Notes

Install the Extron AAP module into the plate opening before or after panel mounting depending on cable routing access. AAP inserts are tool-free snap-fit. Ensure the signal cable is dressed behind the panel with adequate slack before seating the AAP insert, as removal requires a flathead release once installed in tight furniture bays.