Cradlepoint TAA-170623-001 Power Line Cord
Overview
The Cradlepoint TAA-170623-001 is a standard AC power line cord engineered for Cradlepoint networking appliances and compatible edge computing equipment. This 1.8-meter (approximately 5.9 feet) cord bridges a standard NEMA 1-15 male connector—the familiar North American wall outlet plug—to an IEC 60320 C7 female connector, the small barrel-shaped inlet found on many compact network devices. TAA (Trade Agreements Act) compliance means this cord meets U.S. federal procurement requirements, a critical detail if your installation must satisfy government supply chain mandates or NDAA sourcing rules.
Key Features
- 125V rated operation: Matches standard North American single-phase residential and light commercial AC power—sufficient for most edge routers and compact gateways. No step-down transformer needed for typical Cradlepoint equipment deployments.
- NEMA 1-15 to IEC 60320 C7 connectivity: The NEMA plug fits any standard outlet; the C7 connector is the correct receptacle for compact Cradlepoint devices. Verify your target appliance has a C7 inlet before ordering—C5 (cloverleaf) and C13 (standard three-prong) are different and incompatible.
- 1.8-meter length: Roughly 5.9 feet of reach. Adequate for desktop, shallow rack, or wall-mounted installations within normal cable management distance. For longer runs, route through conduit or use a power distribution panel instead of chaining multiple cords.
- Black PVC jacket: Standard flame-retardant polyvinyl chloride sheathing protects conductors and resists minor abrasion. Not rated for continuous UV exposure or outdoor direct burial—keep indoors or under eave cover.
- TAA compliance: Documented for federal procurement and NDAA Section 889 supply chain transparency. Required documentation for government contracts and sensitive infrastructure deployments. If your project has no federal procurement mandate, this spec is irrelevant; focus instead on the connector type and voltage match.
- Standard power delivery: No voltage regulation, filtering, or surge suppression on this cord. If your Cradlepoint device requires clean power, consider adding a UPS or surge-protected power strip upstream of this cord. The cord itself carries whatever voltage and noise the wall outlet supplies.
Integration & Compatibility
The TAA-170623-001 works with any Cradlepoint router, gateway, or network appliance featuring an IEC 60320 C7 power inlet. This includes compact mobile edge computing devices, cellular gateways, and SD-WAN appliances in the Cradlepoint lineup. Confirm your specific model has a C7 connector—do not assume all Cradlepoint devices use the same inlet type. Review the target device's datasheet or rear panel photograph before purchasing.
This is a passive power cord; no firmware compatibility, no driver installation, and no configuration required. It either plugs in or it does not. Pair it with a standard grounded outlet (three-pin) for maximum safety, though the NEMA 1-15 connector itself is two-pin legacy design. Modern installations should use grounded power distribution wherever possible.
Deployment Considerations
Verify outlet proximity and cable routing before installation. A 1.8-meter cord leaves little slack in tight cabinet or wall-mounted scenarios; pre-measure the distance from the outlet to your equipment. If you need longer reach, a quality power extension cord rated for the same wattage as your Cradlepoint device is preferable to daisy-chaining multiple power cords.
Store excess cord neatly and avoid kinking or crushing the PVC jacket, which can damage internal conductors and create fire risk. Do not run this cord under carpets, through pinch points, or in high-traffic areas. Inspect the connector and jacket periodically for cracks, discoloration, or burn marks—any sign of heat damage means replace the cord immediately.
What's in the Box
1x Cradlepoint TAA-170623-001 Power Line Cord (1.8m, 125V, NEMA 1-15 to IEC 60320 C7).
Frequently Asked Questions
Q: Is the TAA-170623-001 compatible with my Cradlepoint router?
A: Only if your router or gateway has an IEC 60320 C7 power inlet. Check your device's datasheet or inspect the power connector on the rear or side panel. If you see a small barrel-shaped inlet with two flat pin slots, it's C7-compatible. If the inlet is cloverleaf-shaped (C5) or a standard three-prong female (C13), you need a different cord.
Q: What does TAA compliance mean?
A: TAA (Trade Agreements Act) compliance certifies that this power cord meets U.S. federal procurement rules for domestic and authorized-source manufacturing. Required for government contracts and NDAA Section 889 supply chain transparency. If your project has no federal mandate, TAA is not a functional benefit.
Q: Can I use this cord with a Cradlepoint device rated for 110V?
A: Yes. The TAA-170623-001 is rated for 125V operation, which is within the standard U.S. wall outlet range of 110–120V. No issues. However, if your device specifies a lower voltage (e.g., 12VDC), this cord is incorrect—you need a power supply or adapter, not this AC cord.
Q: Is this cord suitable for outdoor installation?
A: No. The PVC jacket is not UV-stabilized and will degrade under sustained sunlight exposure. Keep this cord indoors or under covered eave areas only. For outdoor Cradlepoint installations, use rated outdoor-grade extension cords or run power through conduit.
Q: What's the maximum wattage this cord can handle?
A: The NEMA 1-15 connector is rated for 15A at 125V (approximately 1875W maximum). Cradlepoint edge routers and gateways typically draw 20–100W depending on model and load. This cord is oversized for typical devices and will not be a bottleneck. Consult your device's power specifications to confirm safe operation.
Ted PerryPerspective based on aggregated IP Security Depot and affiliated engineering team experience.
Power cords are often an afterthought in network deployments, but connector mismatch and TAA compliance oversights cause real friction in federal and enterprise procurement. The Cradlepoint TAA-170623-001 solves both problems at once: it's the correct C7 connector for most compact Cradlepoint gateways, and it's explicitly TAA-compliant, eliminating supply chain verification delays on government contracts and NDAA-sensitive projects.
Technical Highlights:
- 125V / NEMA 1-15 to IEC 60320 C7: Matches standard North American wall outlets and Cradlepoint edge appliance inlets—no adapter needed. Verify C7 connector type on your target device before purchase; C5 and C13 are common alternatives and incompatible.
- 1.8-meter (5.9 ft) reach: Sufficient for typical desktop, shallow rack, or wall-mounted installations. Not a drop-ship convenience cord for long cable runs—measure distance to outlet before committing to this length.
- TAA-certified: Federal procurement and NDAA Section 889 compliant. Only relevant if your contract or organization mandates supply chain transparency; skip if no government mandate applies.
Deployment Considerations:
- Connector type is non-negotiable: this cord only fits devices with C7 inlets. Take 30 seconds to confirm your router or gateway datasheet lists C7 power input before purchasing.
- PVC jacket is not UV-rated—keep indoors or under eave cover. Direct sunlight will degrade the insulation and create fire risk within 6–12 months.
- No surge suppression, filtering, or voltage regulation on this cord. If your Cradlepoint device is in a noisy electrical environment (factory floor, heavy machinery), add a surge-protected power strip or UPS upstream.
Use this cord when deploying Cradlepoint gateways in government or NDAA-sensitive sites and you've confirmed C7 connector compatibility. For commercial or campus networks without federal procurement mandates, this is a straightforward replacement cord—no surprises, no hidden compatibility gotchas.
