Camden CM-PT250M Concealed 1/4" Mortise Mount

Overview

The CM-PT250M is a concealed mortise-mounted power transfer cable conduit with a 1/4" inside diameter and 7" length. This mount is built to route 4-conductor 22-gauge or 2-conductor 18-gauge wire through standard door frame mortises without visible cable runs on the door face. It solves the problem of clean cable routing in retrofit and new-construction access control installations where concealed wiring is required for appearance or security reasons.

Compatibility

The CM-PT250M integrates with access control strike hardware and door release systems that require discrete power and signal routing. It is designed to work with standard mortise cutouts in commercial door frames and compatible with Camden's power transfer cable family. The 1/4" ID accommodates lighter-gauge conductor bundles typical of push-to-exit buttons, card readers, and electromagnetic strikes in small-to-medium access control zones.

Installation Notes

The mortise mount requires routing through a prepared mortise cavity in the door frame. The 7" length spans standard frame depths; verify your door frame thickness before ordering to confirm fit. No tools are required for insertion once the mortise is cut to specification. Cable termination at both ends connects to your strike hardware and control panel via standard wire connections—check local electrical code for any conduit or strain relief requirements in your jurisdiction.