Vertiv Cable Runway Wall Termination KIT 24 in - GL-CR-WTK24

Vertiv GL-CR-WTK24 Cable Runway Wall Termination Kit 24"

Overview

The GL-CR-WTK24 is a 24-inch wall termination kit for Vertiv's Geist cable runway system, designed to provide a clean, mechanically secure endpoint where overhead cable runway meets a vertical wall surface. Without a proper termination point, runway runs left open at a wall create cable sag, unsupported weight stress on splice hardware, and a code-non-compliant open edge — this kit addresses all three. It fits installations where horizontal cable management terminates at a wall rather than a rack or another runway segment, a common layout in IDF rooms, equipment closets, and data center perimeters where cable pathways run wall-to-wall.

Compatibility

The GL-CR-WTK24 is engineered specifically for the Vertiv Geist GL-series cable runway system at 24-inch runway width. Compatible runway accessories in the same family include the GL-CR-WTK6 (6-inch wall termination variant), GL-CR-BSK butt splice kit, GL-CR-JSK junction splice kit, GL-CR-VWB vertical wall bracket kit, and GL-CR-VSB vertical support bracket. This kit is sized for 24-inch-wide cable runway runs only — do not attempt to use with 6-inch runway without the WTK6 variant. It pairs naturally with GL-CR-CRP4 and GL-CR-CRP8 cable retaining posts to secure cable bundles at the termination point, and with GL-CR-SHbk slotted hanger brackets upstream for mid-span support leading to the wall endpoint.

Installation Notes

Install this kit at the final runway section before the wall surface. The vertical wall bracket (GL-CR-VWB, sold separately) is the recommended anchor point — confirm wall substrate can support the combined dead load of the runway, hardware, and fully-loaded cable bundle before mounting. Hardware drawings (HDW-2-FLMT and HDW-4-FLMT technical drawings) are available from Vertiv for fastener specifications. For runs terminating above a rack or enclosure, evaluate GL-CR-EC vinyl end caps as an alternative to this termination kit — end caps suit open-air endpoints, while the WTK24 is the correct choice when the runway physically meets a wall plane. Reference Vertiv's installation instructions PDF (available on the Vertiv product page) for torque and fastener guidance specific to the GL-series runway hardware.