Vertiv GL-CR-WTK12 Cable Runway Wall Termination Kit

Overview

The Vertiv GL-CR-WTK12 is a wall termination kit designed to cleanly transition a 12-inch-wide cable runway run into a wall-mounted termination point — the finishing piece that keeps overhead cable management from ending in an unsupported, code-unfriendly drop at the wall. If you're routing cable runway through a data center, server room, or structured cabling environment and need a code-conscious, mechanically sound endpoint where the runway meets a wall-mounted tray, patch panel bay, or equipment rack, this kit handles the transition without improvised field fabrication. Available in 6", 12", 18", and 24" widths to match the runway width already in use; the GL-CR-WTK12 covers the 12" runway variant.

Compatibility

The GL-CR-WTK12 is designed for use with Vertiv cable runway systems in the GL series lineup. It is sized for 12-inch-wide cable runway — confirm your installed runway width before ordering, as wall termination kits are width-specific and are not interchangeable across the 6", 18", or 24" variants in the same family. Verify fit against the specific Vertiv GL cable runway model installed in your environment; mixing runway generations or third-party runway with this termination kit is not supported by the manufacturer.

Installation Notes

Color is black. Installation is specific to the wall termination interface — ensure the runway elevation and wall-entry point are fixed before mounting, as repositioning after termination hardware is set typically requires disassembly. Consult the Vertiv GL cable runway installation documentation for torque specifications and hardware sequence. No additional cable runway width adapters are included; the kit addresses termination only, not width transitions.