Vertiv ESC-K6-7 Cable Management Fingers — 7RU x 7-inch Deep, Qty 6

Overview

The Vertiv ESC-K6-7 provides a set of six horizontal cable management finger units, each spanning 7RU in height at 7 inches of depth. These fingers route and retain patch cords, power cables, and structured cabling runs along the sides or front of a rack bay, keeping cable slack under control and preventing sag or tension that shortens connector life. The 7-inch depth suits mid-density rack builds where a shallow finger would leave excess cable looping into adjacent equipment.

Compatibility

Designed for use with Vertiv rack enclosures and open-frame racks in the compatible ESC cabinet series. Verify your rack's finger mounting rail pitch and unit spacing before ordering — the ESC-K6-7 is dimensioned for the specific ESC family and may not retrofit to third-party rack rails without adapter brackets. For high-density patching environments consider pairing with a structured cabling patch panel to maximize the benefit of organized finger routing.

Installation Notes

Mount the finger units to the designated side or front rail channels of the ESC enclosure. Confirm available RU space in your rack layout before installation — six units at 7RU each require careful pre-planning in populated cabinets. Route cables into the fingers before securing final terminations to avoid rework. For large cable bundles in network rack builds, dress cables with hook-and-loop ties inside the finger channel rather than zip ties, which can compress jackets and increase crosstalk in high-density Cat6A or fiber runs.