Comelit HFX-9500M Bello Kit and Maxi Simplebus 2 Door Entry System
Overview
The HFX-9500M is a pre-programmed, ready-to-deploy door entry kit built on Simplebus 2 protocol. It pairs a 7" hands-free Maxi indoor monitor (art. EX-9000H) with the new Bello external entrance panel (art. EX-B) and includes a dedicated power supply (art. 1209/8). The kit addresses small-to-medium entry control deployments—retail storefronts, office buildings, residential complexes—where you need a cohesive system out of the box without custom programming overhead.
Compatibility
The HFX-9500M operates on Comelit Simplebus 2 architecture. Expansion is supported up to 4 external entrance units and 8 internal door entry monitors on a single system, allowing scaling from single-door storefronts to multi-entry commercial installations. All components integrate natively via Simplebus 2 wiring; third-party ONVIF or SIP gateways are not supported within this kit topology.
Installation Notes
The system arrives pre-programmed and ready for deployment—no address setting or protocol configuration required. Install the Bello external panel at the entrance, run Simplebus 2 twisted-pair cabling back to the power supply and Maxi monitor indoors, and power the unit via the included 1209/8 supply. Verify cabling distances: Simplebus 2 runs should not exceed manufacturer limits for the wire gauge used. If expansion beyond the included two units is planned, additional entrance panels and monitors must be sourced separately and paired to the existing system via standard Simplebus 2 addressing.
What's in the Box
- 1x Maxi 7" hands-free door entry monitor (art. EX-9000H)
- 1x Bello external entrance panel (art. EX-B)
- 1x Power supply unit (art. 1209/8)
