Panduit CPUDCAPBL-X 45-Degree Up/Down Port Cap for TX6A Cat6A UTP — 10-Pack

Overview

The Panduit CPUDCAPBL-X is a 10-pack of 45-degree angled dust and protection caps designed specifically for TX6A Cat6A UTP ports oriented in up or down-facing positions. In high-density network patch panels and cable management trays where ports angle upward or downward — common in data center top-of-rack runs and telecommunications room consolidation points — standard inline caps either don't seat properly or create cable management conflicts. These angled caps seat flush, keep debris and accidental snag damage out of unused ports, and maintain the clean, auditable appearance that structured cabling standards call for. CPUDCAPBL-X is the right pick when your TX6A installation has angled-port positions left vacant and you need to keep them protected without fighting the geometry.

Compatibility

Designed for use with Panduit's TX6A Cat6A UTP port system. Compatible with TX6A-series jacks, patch panels, and modular faceplate inserts that expose a 45-degree up or down port orientation. Verify port angle before ordering — Panduit's TX6A line also uses straight (inline) and angled-side configurations; CPUDCAPBL-X is specific to the up/down geometry. Supports Category 6A infrastructure rated to 500 MHz and 10 Gbps, consistent with structured cabling deployments built to TIA-568-C.2 and ISO/IEC 11801. Not intended for shielded (STP/SFTP) TX6A variants — those use a keyed cap to accommodate the shield continuity clip.

Installation Notes

Press-fit installation — no tools required. Each cap snaps into the TX6A port opening and seats against the port body to block dust ingress. In active patch environments, cap all vacant ports immediately after termination; leaving ports open in raised-floor or plenum spaces accelerates contamination buildup that degrades connector performance over time. The 10-pack quantity suits a single 24-port patch panel run with partial population, or spot-fills across multiple panels. UL Listed.