2N 01291-001 IP Verso 3 Module Surface Installation Frame
Overview
The 2N 01291-001 is a dedicated surface-mount frame engineered for the modular 2N IP Verso intercom platform. It accommodates up to three intercom modules in a single assembly, eliminating the need for ad-hoc mounting hardware and reducing installation complexity. The nickel finish is durable against weathering and architectural fade, fitting both residential and commercial deployments. Install this frame on walls, door frames, or flat vertical surfaces where you need a professional, integrated appearance without custom fabrication or field alignment work.
Compatibility
This frame is designed exclusively for the 2N IP Verso intercom family. It supports mounting of up to three Verso modules — including Bluetooth, touchscreen, camera, or standard audio modules — in any combination. If you're building a multi-module access control or intercom setup using the 2N IP Verso platform, this frame is the standard mounting solution; do not attempt to field-mount Verso modules without a purpose-built frame, as misalignment of interconnects will compromise audio and control signal integrity.
Installation Notes
Surface-mount design requires a flat, vertical substrate (masonry, drywall, or metal stud). The frame uses standard fastening hardware suitable for your wall substrate — anchor selection depends on material and load (three modules add approximately 3–5 lbs total). Ensure the mounting surface is level and free of vibration sources to prevent acoustic feedback during two-way SIP calls. All module-to-frame electrical connections are internal; verify module seating before power-up to avoid intermittent relay or sensor failures. The nickel finish is corrosion-resistant in standard indoor and covered outdoor environments; avoid direct salt spray or harsh chemical exposure.
What's in the Box
- 1x 3-module surface installation frame (nickel)
- Mounting hardware (fasteners for typical drywall/masonry installation)
