Bosch IP-10D-TW 250W Transformer Input Panel

Overview

The IP-10D-TW is a 250W transformer input panel designed for 10-inch display systems requiring regulated power conditioning and bridge-sensor signal amplification. It converts low-level millivolt transducer signals into regulated ±10 Vdc outputs while supplying stable excitation voltage to strain-gage and bridge-based sensors — essential for eliminating noise artifacts and voltage-drop errors in sensor chains running to remote data acquisition systems.

Compatibility

This panel integrates with Bosch 10-inch monitor systems and compatible bridge-based transducer chains requiring 3V, 5V, or 10V selectable excitation. It accepts 18–32 Vdc supply voltage and outputs ±10 Vdc (three-wire), making it suitable for industrial measurement and surveillance infrastructure where sensor signal integrity is critical. Verify your specific 10-inch display model for exact mounting and interface requirements.

Installation Notes

Mount using #6 or #8 screws. The IP-10D-TW provides NEMA 4 (IP66) sealing, protecting against direct spray and dust ingress — rated for -15°C to 71°C (-5°F to 160°F) operation. Configurable filter settings (1 Hz through 1 kHz) allow tuning for site-specific electrical noise environments. Current draw is 60 mA dc at the transducer interface; verify your 18–32 Vdc supply can deliver the combined load. Zero and span adjustments support ±30% coarse and ±15% fine tuning to match transducer impedance (350–5000 ohm bridge range).