QNAP 16GB DDR3 Ecc Ram 1600 MHZ Long-Dimm - RAM-16GDR3EC-RD-1600

QNAP RAM-16GDR3EC-RD-1600 16GB DDR3L ECC Long-DIMM Memory Module

Overview

The RAM-16GDR3EC-RD-1600 is a 16GB DDR3L ECC memory module designed to expand RAM capacity in compatible QNAP NAS systems. Running at 1600 MHz with a 240-pin Long-DIMM form factor, this module addresses the memory ceiling that limits simultaneous virtual machine workloads, large iSCSI targets, and multi-user database or surveillance recording tasks. ECC (Error-Correcting Code) support means single-bit memory errors are detected and corrected on the fly — critical in always-on NAS storage environments where silent data corruption is a real risk under sustained I/O load. The DDR3L low-voltage specification also reduces heat output in high-density enclosures. Factory-new and genuine, sourced direct from the manufacturer.

Compatibility

This module is designed for QNAP NAS enclosures that accept 240-pin Long-DIMM DDR3/DDR3L memory, including high-capacity tower and rackmount units in the QNAP TVS, TS, and SS series families that support ECC unbuffered DIMMs. Verify your specific model against QNAP's official memory compatibility list before ordering — not all QNAP enclosures support ECC, and Long-DIMM slots are distinct from SO-DIMM slots used in smaller desktop units. Mixing ECC and non-ECC modules is not supported; if your system currently runs non-ECC RAM, a full replacement to ECC is required to enable error correction. For large-scale deployments pairing upgraded NAS units with network switches, confirm that your switch infrastructure supports the throughput your expanded NAS capacity will demand.

Installation Notes

Power down the NAS fully before installing — hot-swap memory is not supported on QNAP enclosures. Ground yourself with an anti-static wrist strap before handling the module; DDR3L ICs are sensitive to electrostatic discharge. Seat the 240-pin Long-DIMM firmly until both retention clips lock. After reassembly, QNAP's system interface will display the updated memory capacity upon boot. If the system fails to POST or reports a memory error, reseat the module and verify slot compatibility in your enclosure's hardware guide. Review memory upgrade options for additional capacity configurations across compatible platforms.