Altronix VERTILINE63DV 16-Output 24VDC Rack Mount Power Supply
Overview
The Altronix VERTILINE63DV is a 1U rack mount DC power supply delivering 24VDC at 8A total across sixteen independently PTC-protected outputs — purpose-built for access control and security system integrators who need clean, distributed power for door controllers, card readers, and low-voltage field devices in a single rack unit. If you're running a multi-door access control system on 220VAC infrastructure (common in international deployments, industrial environments, and older commercial buildings in regions with 220V mains), this unit feeds up to sixteen devices from one managed power node with per-output fault isolation and LED status on every channel.
The Altronix power supply lineup is a staple in commercial security infrastructure, and the VERTILINE63DV sits in that catalog as the 16-output, 24VDC, 220VAC-input variant — useful when you need more output channels than the 8-output version or require 220V compatibility instead of the standard 110VAC variants. It ships NDAA Section 889 and TAA compliant out of the box, which clears the path for federal, government, and DoD-adjacent projects where supply chain compliance is a procurement requirement.
Key Features
- Sixteen PTC-Protected Outputs: Each of the 16 outputs is individually protected by a resettable Polymeric Positive Temperature Coefficient device. When a connected device draws excessive current or shorts, that output trips and resets automatically — no blown fuses, no service call to swap a fuse block. On a multi-door deployment, one shorted reader doesn't take down the rest of the panel.
- 24VDC @ 8A Total Output: The supply delivers 24VDC with up to 8A across all outputs combined. Per-output rating is 0.5A typical with a 2.5A per-port maximum — sized correctly for card readers, electric strikes, and small door controllers. Plan your load distribution; a single output can handle a 2.5A mag-lock, but total draw across all 16 channels cannot exceed 8A.
- 220VAC 60 Hz Input: The 220VAC input makes this the correct choice when your rack is fed from 220V mains rather than the 110V standard in most US facilities. Draws 1.5A at input, with a 330VA system AC requirement — a relatively light load on a 220V circuit. Pair with appropriately rated circuit protection on the input side.
- Filtered and Electronically Regulated Outputs: Active regulation holds 24VDC steady under varying load, and output filtering suppresses noise that can interfere with sensitive access control readers and low-voltage sensors. Unregulated supplies introduce voltage sag that causes intermittent reader failures at load peaks — regulated outputs eliminate that diagnostic headache.
- Sixteen Status LEDs + Illuminated Master Breaker: Every output has a dedicated power LED, so you can confirm each circuit is live at a glance during commissioning or troubleshooting. The illuminated master power disconnect doubles as a manual reset circuit breaker — no separate breaker to locate in a crowded rack.
- 1U EIA 19
