ELO Touch E582895 DisplayPort to DisplayPort Video Cable

Overview

The ELO Touch E582895 is a 1.8-meter DisplayPort-to-DisplayPort video cable designed to connect display sources to ELO Touch interactive displays and monitor systems. This cable carries uncompressed digital video over a single cable run, eliminating the signal degradation and sync issues common with older analog connections. At 1.8 meters (approximately 5.9 feet), it fits standard desk setups, wall-mounted installations, and equipment racks where source devices sit within 6 feet of the display.

Compatibility

This cable works with any ELO Touch display or monitor featuring a native DisplayPort input connector. It also pairs with standard PC graphics cards, media players, laptop docking stations, and AV processors equipped with DisplayPort output. Verify your source device has a DisplayPort output connector (not VGA, HDMI, or DVI) before ordering — pin compatibility is direct.

Installation Notes

DisplayPort is a hot-swappable standard; you can connect or disconnect the cable while the source device is powered on without risk of damage. Avoid sharp bends near the connectors, as excessive strain can compromise the latch mechanism. The cable carries both video and optional audio data, so no separate audio cable is required if your display has built-in speakers or the source is feeding audio over DisplayPort. For permanent installations, use cable management clips or conduit to protect the run from accidental foot traffic or pinching.