Middle Atlantic 1 1/2-GANG Pass Through H - 15FFHA

Middle Atlantic 15FFHA 1.5-Gang Pass-Through Horizontal Raceway

Overview

The Middle Atlantic 15FFHA is a 1.5-gang horizontal pass-through fitting designed to route cables cleanly through rack enclosure panels without sharp bends or abrasion points. The 15FFHA fills a 1.5-gang knockout or pre-cut opening and provides a finished, strain-relief-friendly aperture for power, data, or AV cabling passing between rack zones — a common requirement in wall-mount enclosures and millwork integrations where cable entry points need to look finished and prevent jacket damage over time. If you are managing cable ingress on a Middle Atlantic enclosure and need a clean, low-profile solution that does not consume a full rack unit, this fitting addresses that specific problem. For larger cable bundles or higher cable counts, consider a wider multi-gang variant in the same fitting family.

Compatibility

The 15FFHA is designed for use with Middle Atlantic rack enclosures and furniture that feature 1.5-gang accessory openings — including the Middle Atlantic SLIM series, BGR series, and comparable wall-mount and floor-standing enclosure lines that ship with pre-configured gang knockout patterns. Verify your enclosure's gang opening size before ordering; Middle Atlantic uses standardized gang dimensions consistent with common low-voltage plate sizing, but confirm the specific knockout count and cutout dimensions in your enclosure's installation guide. This fitting is not compatible with standard 1U or 2U rack panel blanks that lack gang-style cutouts. It pairs naturally with horizontal cable management panels and structured cabling accessories within the same enclosure build.

Installation Notes

Installation requires no special tooling — the 15FFHA snaps or screws into the gang opening depending on the enclosure model. Route cables through the aperture before terminating connectors where plug bodies would not clear the opening. For clean installs in finished environments, pair with Middle Atlantic brush-insert or grommet accessories if the application requires dust control or a fully sealed appearance. Confirm cable jacket outer diameters fit the pass-through clearance prior to final termination.