Wasp 633808471187 WCD-5000 Cash Drawer USB Cable

Overview

The Wasp 633808471187 is a USB connection cable purpose-built for the WCD-5000 cash drawer. It bridges USB host devices—POS terminals, kiosks, or registers—to the drawer's solenoid lock mechanism, enabling automated pop and close cycles tied to transaction workflows. Deploy this where you need drawer control integrated directly into your register software without middleware or separate controller hardware.

Compatibility

This cable is designed specifically for the Wasp WCD-5000 cash drawer series. Verify your drawer model matches WCD-5000 before ordering—different Wasp drawer generations may use incompatible connector types or pinouts. Confirm USB host compatibility with your POS terminal or register documentation; any device with a standard USB port and software support for solenoid control will work. The cable carries both power and signal over USB, requiring no separate power supply or driver installation.

Installation Notes

Connect the USB end to an available USB port on your POS device or control terminal. Attach the drawer end connector to the WCD-5000's signal connector. Route the cable away from high-traffic areas and repeated stress points to avoid premature connector wear. Test drawer pop and close cycles immediately after installation to verify proper signal transmission and solenoid response before live transaction use.