Wasp 633808431280 2.25x1.25 DT Paper Label

Overview

The Wasp 633808431280 is a 2.25-inch by 1.25-inch direct thermal paper label stock, 1135 labels per roll, 4-inch outer diameter with perforation. This is consumable media for Wasp thermal label printers running direct thermal mode (no ribbon required) — typical for warehouse barcode labels, inventory tags, and shipping marks where label volume is high and cost per unit matters.

Compatibility

Direct thermal paper labels work with any Wasp thermal printer configured for DT mode. Verify your printer supports direct thermal operation before ordering — some models require ribbon cartridges and cannot switch to DT-only. The 4-inch OD roll format fits standard roll-feed spindles on most desktop and commercial Wasp label printers. Check your printer's media width spec: this label is 2.25 inches wide, so your printer must support that width range.

Installation Notes

Direct thermal paper is sensitive to heat, light, and humidity. Store in a cool, dry location (60–75°F, below 50% relative humidity) to avoid darkening or premature image fading. Once installed on the printer spindle, keep the label roll covered when not actively printing. If labels sit exposed to fluorescent light for extended periods, image contrast may degrade. Load the roll with the print side facing the print head and the leading edge feeding downward into the platen.

What's in the Box

• 1x roll of 2.25x1.25 direct thermal paper labels (1135 labels per roll, 4-inch OD with perforation)