Viking Electronics SP545-BLTIP VoIP Emergency Phone EWP IP Replacement Kit
Overview
The SP545-BLTIP is a replacement kit for Viking Electronics' EWP IP series VoIP emergency phones. When a handset cord or splitter on an installed Viking VoIP emergency phone reaches end of life or sustains damage, this kit provides the exact components needed to restore full operation without replacing the entire unit. The SP545-BLTIP includes a 25 ft split cord — long enough to accommodate most wall-mount and pedestal installations — along with a 5 in handset splitter sized to reach the handset jack on nearly any digital phone in Viking's lineup.
Compatibility
Designed for Viking Electronics EWP IP series VoIP emergency phones. The 5 in splitter length is specifically engineered to reach the handset jack of Viking digital phone models that a shorter splitter cannot serve. Verify your installed EWP IP model against Viking's current accessory compatibility list before ordering if you are unsure of the handset jack location on your specific unit.
Installation Notes
The 25 ft split cord provides adequate slack for routing in most surface-mount and recessed enclosure installations. Route the cord clear of sharp edges and avoid over-tensioning at the jack connection points — emergency phone installations in high-traffic or vandal-prone areas benefit from securing the cord with cable clips at regular intervals to prevent pull stress on the handset jack. No tools beyond basic hand tools are required for cord and splitter swap-out.
