ATEN LIN2-418K-D12G USA Plug to IEC C13 Power Cord
Overview
The ATEN LIN2-418K-D12G is a UL-listed power cord terminated with a USA (NEMA) plug on one end and an IEC C13 connector on the other — the standard pairing for powering rack-mounted equipment in North American deployments. If you're connecting a KVM switch, PDU, or rackmount appliance that ships without a region-specific cord, this is the direct replacement or supplemental cable to reach your PDU or wall outlet. LIN2-418K-D12G is a genuine ATEN accessory sourced to match the electrical and mechanical tolerances of ATEN equipment.
Compatibility
The IEC C13 female connector fits any device with an IEC C14 inlet — including ATEN KVM switches, LCD console drawers, rackmount matrix switches, and compatible third-party equipment using the same inlet standard. The USA plug end connects to standard North American NEMA 5-15R outlets and compatible PDU receptacles. Verify your specific ATEN model's inlet type and required amperage rating before ordering; not all ATEN rackmount products share the same power inlet configuration.
Installation Notes
Seat the IEC C13 connector fully until the retention clip engages — a partially inserted C13 under load is a reliability risk in vibration-prone rack environments. Route away from sharp edges and cable tie-down points that could stress the jacket. Do not exceed the cord's rated current capacity; check your device's nameplate amperage against the cord's rating before installation.
