Unitech 5400-900069G HT730P Glass Screen Protector

The 5400-900069G is a glass screen protector built for the Unitech HT730P mobile computer, sold as a 10-piece box for fleet-scale deployment rather than one-off replacement. If you're running HT730P units on a warehouse floor or dock where screens take daily abuse from scanning, gloved-hand input, and drop contact, this keeps a spare stock on hand so a scratched or cracked protector is a 30-second swap instead of a device pulled from rotation.

Overview

Each box ships as HT730P-specific glass, sized and cut for that unit's display and sensor cutouts. Stocking a 10-pack per device deployment means field techs or warehouse leads can replace protectors as they wear without waiting on a reorder — relevant for any site running the HT730P as its primary mobile computers handheld.

Compatibility

This protector is cut specifically for the Unitech HT730P mobile computer. It is not a universal or trim-to-fit design, so confirm the device model before ordering — glass protectors sized for other Unitech handhelds (PA700, EA630, or HT700-series) will not align with the HT730P's screen and camera/scanner openings.

Installation Notes

Glass protectors of this type install dry or with an adhesive layer over the display, with cutouts pre-aligned to the HT730P's screen bezel. Clean the display surface before application to avoid trapped debris under the glass, which shows as visible bubbling or dust spots.

Country of origin is Taiwan, and the unit weighs 0.58 lbs per 10-pack box — light enough to bundle into a standard accessory order alongside Unitech mobile computers or a replacement case or holster for the same device. For fleet managers standardizing spares across a deployment, see the mobile computer selection guide for guidance on matching accessories to device generation. Pair this with a Unitech accessories order to consolidate a single PO for screen protection and carry gear across a rollout.