Ubiquiti UACC-CAMERA-AM-W Arm Mount Accessory
Overview
The UACC-CAMERA-AM-W is a structural arm mount designed to attach the Ubiquiti G5 Turret Ultra camera to walls, corners, and poles. This accessory bridges the gap between the camera and the mounting surface, enabling secure positioning in multi-camera deployments where the camera body alone does not provide adequate standoff or angle flexibility. Use this when you need the camera offset from the wall plane — typical in retail corridors, warehouse entrances, or building perimeters where direct wall-mount positioning blocks sight lines or creates awkward cable routing.
Compatibility
This mount is engineered exclusively for the Ubiquiti G5 Turret Ultra camera. Verify your camera model before ordering — it will not fit other Ubiquiti camera families or third-party turret designs. The arm accepts standard wall anchors and pole-clamp hardware (not included) common to commercial mounting systems.
Installation Notes
Mount the arm to wall, corner, or pole surfaces using appropriate fasteners rated for your substrate (masonry, wood, steel). Ensure the arm is fully seated on the camera base before tightening all connection points. The camera will hang from the arm — load is distributed across the full contact surface, not a single fastener. Once mounted, position the camera for your desired field of view and ensure cables exit downward or horizontally to avoid water pooling at connector points. Weight limit is determined by the structural strength of your wall or pole mounting point, not the arm itself.
What's in the Box
- 1x Arm mount accessory (UACC-CAMERA-AM-W)
