TSC OP-P-BC1-001-1001 1-Slot Battery Charger
Overview
The TSC OP-P-BC1-001-1001 is a single-slot battery charger for TSC portable thermal printers operating in warehouse, distribution, and field-service environments. This accessory solves the mobility bottleneck in multi-unit deployments: keep printers in the field longer by rotating charged batteries through a dedicated charging station rather than tethering devices to power between shifts. Designed for Alpha 30 and Alpha 40 printer series, the OP-P-BC1-001-1001 supports hot-swappable battery workflows — critical for high-volume labeling operations where printer downtime directly impacts throughput.
Compatibility
The OP-P-BC1-001-1001 is engineered for TSC Alpha 30 and Alpha 40 portable thermal printer systems. Before ordering, confirm your printer model matches this series and that your battery type aligns with TSC's standard configurations for these platforms. If you operate multiple printer models or use non-standard battery variants, verify compatibility with your device documentation.
Installation Notes
The charger is designed for stationary desk or cart-mounted operation in dry indoor environments. Connect to standard US mains power (120V typical — verify your regional voltage before installation). Position the unit away from moisture, direct sunlight, and temperature extremes. Allow adequate ventilation around the charging slot to prevent thermal stress on the battery during multi-hour charge cycles. No special tools or configuration are required — the charger integrates with existing TSC portable printer fleet deployments without additional software or driver setup.
