Altronix T1V3CK1D Pre-Wired 4-Door Access Control Power Supply with Battery Backup
Overview
The Altronix T1V3CK1D is a pre-wired, UL294-listed power supply and battery backup enclosure built for commercial 4-door access control deployments. Designed to eliminate field wiring time on multi-door installs, it ships ready to connect — the internal harness is factory-terminated, so your technician lands the field wires rather than building the distribution from scratch. The T1V3CK1D outputs both 12VDC and 24VDC at up to 6A continuous, giving you the flexibility to power mixed-voltage door hardware — electric strikes, mag locks, and access control panels — from a single enclosure. For integrators running access control systems in commercial facilities, this kind of plug-and-play distribution saves meaningful labor hours per installation.
Altronix has built this unit around the practical demands of enterprise access control: dual battery backup, UL294 and cUL s319-05 agency listings, and a steel enclosure sized for real conduit runs. Browse the full Altronix power supply catalog for related units in the same product family.
Key Features
- 12VDC and 24VDC Dual-Voltage Output: Supports mixed-voltage door hardware from a single enclosure — no secondary power distribution needed when your install includes both 12V electric strikes and 24V mag locks on the same riser.
- 6A Continuous Output Current: Enough headroom for four active doors with standard electromagnetic locking hardware without tripping into current limiting. Size your door hardware loads accordingly — 6A continuous is the sustained ceiling, not a peak rating.
- Pre-Wired for 4 Doors: Factory-terminated internal harness eliminates field wiring of the distribution block. A technician lands field cables directly — typical 4-door wiring time is compressed significantly versus building distribution from raw terminal blocks.
- Dual 12VDC/7AH Battery Backup: Accommodates up to two 12VDC/7AH batteries internally, providing standby power during AC outages. For a 4-door install with modest load, two 7AH batteries typically sustain several hours of holdover — verify against your specific lock and panel draw calculations before finalizing battery sizing.
- 120VAC / 60Hz Input, 3.5A Draw: Standard North American mains input. At 3.5A draw, a single 15A branch circuit comfortably powers multiple units — relevant on multi-enclosure riser closets where circuit allocation matters.
- UL294 and cUL s319-05 Listed, CE Marked: UL294 is the access control equipment standard — this listing satisfies AHJ requirements on most commercial projects. cUL s319-05 covers Canadian installations. CE marking supports international deployments where required.
- Conduit Knockouts — 1 × 1-1/2
